User manual

tams elektronik
WIB-33.2 English
Auxiliary functions
Name of CVs /
Registers
CV-
no.
Reg.
no.
Input value
(Default)
Remarks and Tips
Settings
Reset 8 03 0 ... 255 Any input value restores the
settings in state of delivery.
Basic settings
Name of CVs /
Registers
CV-
no.
Reg.
no.
Input value
(Default)
Remarks and Tips
Settings
Configuration
data 1
29 10 0 ... 64 (14) Direction "Standard" 0
Reverse direction 1
14 speed levels 0
28 or 128 speed levels 2
Analogue recognition off 0
Analogue recognition on 4
RailCom off 0
RailCom on 8
Basic addresses 0
Not for MM mode: Extended addresses 32
Factory settings: Direction of travel = "Standard". 28 or 128 speed levels. Automatic analogue
recognition = "on". RailCom "on". Basic addresses.
Example: CV#29 = 0. à Direction = "Standard". 14 speed levels. Automatic analogue
recognition = "off". RailCom = "off". Basic addresses.
Example: CV#29 = 46. à Direction = "Standard". 28 or 128 speed levels in DCC-mode.
RailCom = "on". Automatic analogue recognition = "on". Extended Addresses.
Tip: If the use of extended addresses is activated in CV#29, the decoder does not react to
signals in Motorola format!
Settings for analogue mode
Name of CVs /
Registers
CV-
no.
Reg.
no.
Input value
(Default)
Remarks and Tips
Settings
unctions
active in
analogue
mode
(only for F1 to
F8, not for F9
to F12)
13 05 0 ... 255 (15) F1 on 1
F2 on 2
F3 on 4
F4 on 8
F5 on 16
F6 on 32
F7 on 64
F8 on 128
Factory settings: F1, F2, F3 and F4 activated in analogue mode (CV#13 = 1+2+4+8=15)
RailCom settings
Name of CVs /
Registers
CV-
no.
Reg.
no.
Input value
(Default)
Remarks and Tips
Settings
RailCom-
settings
(not for
operation in
Motorola format)
28 –- 0, 1, 2, 3 (3) Broadcast on 0
Broadcast off 1
Messages in channel 2 off 0
Messages in channel 2 on 2
Remark: When using the carriage lighting in a block train with other RailCom decoders it is
recommended to switch off the RailCom broadcast. Otherwise disturbances in transmitting the
address may occur.
Page 15