User manual

tams elektronik
!
LED-Control English
Connect the LED(s) according
to the connection diagramm to
the connecting points X1 and
X2.
Connecting train rear lanterns:
Caution:
The LEDs shaped like train
rear lanterns have to be
mounted according to the
connection diagram! The
longer lead is not in general
the anode (+)!
Mounting the train rear lanterns
In order to fix a LED shaped like a train rear lantern safely, it is
recommended to use a PCB of its own for each LED.
Fix the PCB on the inside of the carriage´s board beside the holes
needed to feed through the legs of the LED. Take care to mount the
connecting points for the LED directly beside the holes. Bend the legs of
the LED in direction of the PCB, when fed through the hole. Shorten the
legs so that they end directly above the connecting points and then
solder them.
Page 15