User manual

Multi-Timer English
Required materials
For assembling the kit you need:
 an electronic soldering iron (max. 30 Watt) or a regulated soldering
iron with a fine tip and a soldering iron stand,
 a tip-cleaning sponge,
 a heat-resistant mat,
 a small side cutter and wire stripper,
 as necessary a pair of tweezers and long nose pliers,
 electronic tin solder (0,5 mm. diameter).
In order to connect the module you need wire. Recommended
diameters:
> 0,10 mm² for buttons and switches (e.g. item no. 73-1021x, x=0..9),
> 0,25 mm² for all other connections (e.g. item no. 73-1031x, x=0..9).
For testing the module you need an electric light bulb with a separate
power supply and a switch.
For the connection to the switching inputs you need:
 for use as a time switch or a pulse delay:
four push buttons, e.g. item no. 84-5212x, x=1..5 (or circuits to
release a switching pulse);
 for use as a random switch:
four switches, e.g. item no. 84-51510 (or comparable circuits);
 for use as a start-brake-stopover switch:
one switch, e.g. item no. 84-51510 (or a circuit to switch over the
signal);
one reed kontact (e.g. item no. 84-53110) or Hall sensor (e.g. item
no. 84-53210) in combination with a magnet (e.g. item no. 84-
53990)
or a photoelectric barrier or similar for initiating of braking;
Page 33
tams elektronik