User manual

Multi-Timer English
the switching on, this has no effect until the Multi-Timer has been
switched off and on again.
The operation modes 1 and 2 have to be set on the 4 outputs
separately. Therefore you can use the Multi-Timer as a combined time
switch and pulse delay. With the operation modes 3 and 4 the setting is
valid for all four outputs.
With the operation mode 1 "time switch" you can choose whether you
want to retrigger the outputs or not. For the operation mode 4 "start-
brake-stopover switch" you have to define either a low or a high PWM
for the locomotive motor.
Jumper Operation mode
JP2 JP3 JP4 JP5 Output 1 Output 2 Output 3 Output 4
- - - - 1 (r) 1 (r) 1 (r) 1 (r)
- - x x 2 1 (r) 1 (r) 1 (r)
- - x - 2 2 1 (r) 1 (r)
- - - x 2 2 2 1 (r)
x - - - 1 (nr) 1 (nr) 1 (nr) 1 (nr)
x - x x 2 1 (nr) 1 (nr) 1 (nr)
x - x - 2 2 1 (nr) 1 (nr)
x - - x 2 2 2 1 (nr)
- x - - 2 2 2 2
x x - x 3 3 3 3
x x x - 4 (PWM-) 4 (PWM-) 4 (PWM-) 4 (PWM-)
x x x x 4 (PWM+) 4 (PWM+) 4 (PWM+) 4 (PWM+)
- Jumper not
inserted
x Jumper inserted
1 operation mode 1 "time switch"
2 operation mode 2 "pulse delay"
3 operation mode 3 "random switch"
4 operation mode 4 "start-brake-
stopover switch "
(r) to be retriggered
(nr) not to be retriggered
(PWM-) low PWM-rate
(PWM+) high PWM-rate
Page 53
tams elektronik