User manual

tams elektronik
English KSM-2
Connection of the track busy indicator to the layout
The track busy indicator integrated into the KSM-2 which supervises the
section within the loop, is conducted to the outside of the module via
the connection points 1 and 2 and can be integrated into the rest of the
layout´s control system. The galvanic separation enables the direct
connection to digital feed back modules (e.g. s88 modules)
Connect the connecting point 1 of the KSM-2 (= record output) to the
input of the feed back module and the connecting point 2 to the mass
connection of the feed back module.
Connection of a RailCom detector
As a RailCom detector is an electric load, it would create a permanent
busy indication when connected directly to the rails within the loop. The
loop module would not work, in consequence.
The RailCom detector supervising the inner section of the loop has to
be looped in between internal track busy indicator and loop module via
the connections JP1.
As at the time of printing this manual only a few RailCom detectors are
available and future developments are pending we have refrained from
describing the connection of RailCom detectors in detail. Please contact
our technical hotline (address on the cover page) and tell us which
RailCom detector (manufacture, type) you intend to connect. You will
receive free information on connecting it then.
Seite 26