User manual

English s88-BiDiB-Link
6.3. Connecting the PC
Connect the s88-BiDiB-Link via the USB cable included in the package
to you PC. In case the USB interface has not been installed on your PC,
you will receive an appropriate indication. You have to download the
driver from the internet then.
Settings in the software for HSI mode
When transferring data from the interface to the PC in HSI-88-mode,
you have to make the following settings in your software:
 data transfer according to the HSI-88-protocol for serial interfaces,
 number of s88 modules connected to the three bus lines. Hint:
Observe the numbers of the bus lines (see figure in section 4).
Settings in the software for BiDiB
BiDiB has been designed that way connected BiDiB-knots log in
themselves at the software.
S88 modules are administered by the interface as BiDiB-knots when
data transfer to the PC is effected via the BiDiB-protocol.
Page 12