User manual

tams elektronik
!
English S88-3
8. Check list for troubleshooting
 Parts are getting too hot and/or start to smoke.
Disconnect the system from the mains immediately!
Possible cause: one or more components are soldered incorrectly.
à In case you have mounted the module from a kit, perform a
visual check (à section 6.) and if necessary, remedy the faults.
Otherwise send in the module for repair.
 The central unit, the memory or the interface do not show the
proper status.
Possible cause: The connection(s) between the feedback module and
feedback modules connected in series or the digital device are
interrupted. à Check the connections. When using a ribbon cable,
check as well, if the connecting socket of the ribbon cable is put on
in the right direction.
Possible cause: The connection between the input and the mass
contact is interrupted. à Check the connections.
Page 20