User manual

tams elektronik
SD-34 | SD-34.2 English
With Motorola central units the address can be set via the programming
jumper (SD-34) or the programming push-button (SD-34.2) only. When
using DCC central units it is often easier to set the address via the
programming jumper / push-button than to program it via CV.
Hint: Setting the address via the jumper / push-button is impossible
unless the decoder is operated by points addresses. When the
operation via locomotive addresses is set in CV#29, it is impossible to
set the address with the jumper/push-button.
In order to set the address via the programming jumper / push-button
perform the following steps:
1. SD-34: Bridge the two pins of the programming connector JP1, by
putting on the jumper included in the package. Take it away as
soon as the LED flashes.
SD-34.2: Push the programming push-button on the PCB. The LED
flashes.
2. Set one of the addresses from the quadruple accessory decoder
address block you want to use for switching the connected
accessories at the control unit (e.g. address "10" from the
quadruple accessory decoder address block 9 – 12). Perform a
switching command for the chosen address.
3. As soon as the LED goes out, the decoder has taken over the new
address.
Page 25