User manual

tams elektronik
SD-34 | SD-34.2 English
8. Programming the decoder
You can program the configuration variables (CV) using a DCC digital
central unit. See the chapter in the manual of your central unit where
the byte wise programming of configuration variables (CVs) is
explained.
When using a Motorola central unit you can set the decoder address
with a programming jumper (SD-34) or with a programming push-
button (SD-34.2). Changing the other decoder´s features or assigning a
locomotive address is neither necessary in layouts run in Motorola
format only nor possible with Motorola central units.
Programming decoder and accessory decoder addresses
You can set the decoder address either by programming the CVs with
your DCC central unit or by using the programming jumper or push-
button. When setting the decoder address it is of no importance if you
intend to operate the decoder by vehicle decoder commands
(locomotive commands) or accessory decoder commands (points
commands).
The accessory decoder address used to send the switching commands
result from:
Decoder address x 4
= highest address of the quadruple accessory decoder address block
When operating the decoder by locomotive addresses, you use the
function keys F1 to F4 to switch the connected accessories.
Page 23