Instructions
Table Of Contents
- 1. Getting started
- 2. Safety instructions
- 3. Safe and correct soldering
- 4. Operation overview
- 5. Technical specifications
- 6. Connections
- 7. Programming
- 8. Configuration variables and registers
- 9. Check list for troubleshooting
- 10. Guarantee bond
- 11. EU Declaration of Conformity
- 12. Declarations concerning the WEEE directive
- 13. The asterisks **
tams elektronik
English FD-R Basic.3
8.5. RailCom settings
Name No. Input values
(Default)
Remarks and tips
Dynamic
RailCom
information
10 0,1 (1) off 0
Reception statistics:
The decoder keeps statistics on
all DCC packets and reports the
number of faulty packets / total
number of packets in %. 1
In order to read out RailCom information, you have to make the following additional settings:
- CV 29 ("configuration data 1": RailCom on
- CV 28 "RailCom channels": at least channel 2 on
RailCom
channels
28 0 … 7
(3)
no feedback with RailCom 0
Channel 1 on 1
Channel 2 on 2
Dynamic channel 1 use 4
The setting only has an effect if channel 1
is switched on.
Please note that some RailCom detectors can only receive messages on channel 1.
For the decoder to send RailCom messages, RailCom must be switched on in CV 29.
Further information on RailCom → Section 4.5
Page 42