Instructions
Table Of Contents
- 1. Getting started
- 2. Safety instructions
- 3. Safe and correct soldering
- 4. Operation overview
- 5. Technical specifications
- 6. Connections
- 7. Programming
- 8. Configuration variables and registers
- 9. Check list for troubleshooting
- 10. Guarantee bond
- 11. EU Declaration of Conformity
- 12. Declarations concerning the WEEE directive
- 13. The asterisks **
tams elektronik
!
FD-R Basic.3 English
6.2. Connecting accessories to the outputs
Caution:
The maximum current of the accessory must not exceed the maximum
current of the output to which you connect it. The output may
otherwise be irreparably damaged!
Disconnect any existing diodes in the leads to the lamps, otherwise the
lamps might not light. Connect the lamps and the accessories to the
function outputs of the decoder. If the lamp or the accessory is already
connected with one side to vehicle ground, the connection is complete.
If not, connect the second side of the lamp or the accessory to the
decoder´s common return conductor for all function outputs.
You find the factory (default) settings in the lists with the connector pin
assignments (page 18). You can assign the outputs to the function keys
voluntarily by setting the configuration variables.
F0r: Light bulb
F0f: serial connection
of LEDs
AUX2: parallel
connection of LEDs
AUX1: combined
parallel and serial
connection of LEDs
Fig. 1: Examples for the connection of accessories and LEDs to the
function outputs
Page 19