Instructions
Table Of Contents
- 1. Getting started
- 2. Safety instructions
- 3. Safe and correct soldering
- 4. Operation overview
- 5. Technical specifications
- 6. Connections
- 7. Programming
- 8. Configuration variables and registers
- 9. Check list for troubleshooting
- 10. Guarantee bond
- 11. EU Declaration of Conformity
- 12. Declarations concerning the WEEE directive
- 13. The asterisks **
tams elektronik
FD-R Basic.3 English
Programming the effects
Flashing
By assigning the flashing function to 2 outputs
and the "inverted switching" function to one of
the two outputs, an alternating flashing is
generated.
The flashing frequency is set separately for each
output.
CV programming
(CV 58-60, CV 101-104)
Kick function
The outputs first receive full voltage for a
maximum of approx. 25.5 seconds and are then
switched off. The kick time is set separately for all
outputs.
Example of use: Some types of electrical couplings
require full voltage to decouple. However, the
voltage should be switched off after uncoupling in
order to protect the couplings.
CV programming
(CV 58-60, CV 99)
Dimming
To reduce the voltage at the output.
Example of use: The lights of older vehicles
intended for analogue operation can be dimmed
and then do not need to be replaced after the
decoder has been installed.
CV programming
(CV 47-50)
Page 13