User manual

tams elektronik
!
English FD-R Basic 2
10. Check list for troubleshooting
 Parts are getting very hot and/or start to smoke.
Disconnect the system from the mains immediately!
Possible cause: one or more connections are soldered incorrectly.
à Check the connections.
Possible cause: Short circuit. The decoder is connected to locomotive
or carriage ground. à Check the connections. A short circuit can
result in irreparable damage.
Problems with the area "function decoder"
 After programming, the FD-R Basic 2 does not react as intended.
Possible cause: The set values for the CV are inconsistent.
à Perform a decoder reset and first test the decoder with the
default values. Program the decoder anew.
Possible cause: Instead of saving the settings into the function
decoder area the settings were saved into the RailCom transmitter
area of the FD-R Basic 2. à Program the function decoder area
anew, making sure that in CV #888 the value "0" is set.
 An output cannot be switched on.
Possible cause: The values set in CV #49 to #63 for an output,
contradict one another. à Alter the values for CV #49 to #63 .
 The lighting does not correspond to the direction of travel.
Possible cause: The configuration data (CV #29) of the locomotive
decoder in the train vary from the configuration data programmed in
the function decoder. à Change the programming or the function or
the deocder.
 The decoder does not react in analogue mode.
Possible cause: The analogue mode is switched off. à Alter the
value for CV #29.
Page 34