User manual

tams elektronik
FD-R Extended English
Problems in analogue mode
 The decoder does not work in analogue mode.
Possible cause: The analogue mode is switched off.  Alter the
value for CV#29.
 The decoder does not switch to analogue mode (or switches over
although it is still digitally controlled).
Possible cause: The value in CV#11 is set too high or too low.
 Alter the value and check the settings in operation.
Problems with switching via switching inputs
 After passing a permanent magnet in the rails no function is
activated.
Possible cause: The reed contact or the Hall sensor has been
mounted incorrectly.  Check the connections.
Possible cause: The distance to the magnet is too large or the
magnet is too weak.  Alter the position of the magnet (if possible)
or use a stronger one.
Possible cause: The magnet has been mounted incorrectly polarized.
 Alter the mounting direction.
Possible cause: The function has been assigned incorrectly to the
switching input.  Check the settings in CV## 59-64 and 119-121.
Possible cause: The input IN3 is determined for the connection of a
servo (= default value).  Check the settings in CV## 167 and
168.
Page 51