Manual
Table Of Contents
- 1. Getting started
- 2. Operation overview
- 3. Connections
- 3.1. Safety instructions
- 3.2. Safe and correct soldering
- 3.3. Avoiding irreparable damage to the decoder!
- 3.4. Pin assignment LD-G-43 | Front side
- 3.5. Pin assignment LD-G-43 | Rear side
- 3.6. Using decoders with interface connectors
- 3.7. Use of the LD-G-43 in locomotives with AC motor
- 3.8. Mounting decoders without interface
- 3.9. Connecting LEDs to the function outputs
- 3.10. Connecting inductive loads
- 3.11. Connecting the switching inputs
- 3.12. Connecting a backup capacitor or buffer circuit
- 3.13. Connection of a SUSI module
- 3.14. Completion
- 4. Programming
- 5. Configuration variables and registers
- 5.1. Overview configuration variables LD-G-43
- 5.2. Basic settings
- 5.3. Setting the address
- 5.4. Setting the motor control
- 5.5. Function mapping
- 5.6. Effects of the outputs
- 5.7. Settings for the switching inputs
- 5.8. RailCom and DCC-A settings
- 5.9. Settings for driving operation
- 5.10. Settings for analogue mode
- 5.11. Sensivity of the overload protection
- 5.12. Auxiliary functions
- 5.13. Information
- 6. Checklist for troubleshooting and error correction
- 7. Technical data
- 8. Warranty, EU conformity & WEEE
tams elektronik
LD-G-43 tams elektronik
5.7. Settings for the switching inputs
Name No. Input values
(Default)
Remarks and tips
Assignment of the
functions to the
switching inputs
F0 … F7
F0 1
F1 2
F2 4
Switching input 1 105
1 … 255 (0) F3 8
F4 16
Switching input 2 107
1 … 255 (0) F5 32
F6 64
F7 128
Assignment of the
functions to the
switching inputs
F8 … F15
F8 1
F9 2
F10 4
Switching input 1 106
1 … 255 (0) F11 8
F12 16
Switching input 2 108
1 … 255 (0) F13 32
F14 64
F15 128
Minimum switch-
on time of the
switching inputs
= Time period for which the input remains
at least on after it has been connected to
ground.
Increasing the input value by "1" extends
the time period by 0.1 sec.
0 = 0 sec. (off)
255 = 25.5 sec.
Switching input 1 97 0 … 255 (0)
Switching input 2 98 0 … 255 (0)
Example:
The shunting gear (here switched with F3) is to be activated automatically for the duration of the
crossing over a switch road (here 10 seconds).
CV 105 = 8 (assignment of the switching input 1 to F3)
CV 97 = 100 (= 10 seconds)
54 | Configuration variables and registers