User manual

Locomotive decoders of the series 30 plus English
Required materials
For mounting and connecting decoders without interface you need:
 an electronic soldering iron (max. 30 Watt) or a regulated soldering
iron with a fine tip and a soldering iron stand,
 a tip-cleaning sponge,
 a heat-resistant mat,
 a small side cutter, a wire stripper and a pair of tweezers,
 electronic tin solder (0.5 mm diameter).
In order to connect decoders without interface or soldered connecting
wires you will need wire. Recommended cross sections:
 > 0,04 mm² for the connections to the function outputs;
 > 0,05 mm² for the connections to the motor and current collectors
(except for the LD-G-34 plus);
 > 0,14 mm² for connections to the motor and current collectors of
the LD-G-34 plus.
For playing back the sounds you need:
 a loudspeaker with an impedance of min. 4 Ohm and a rated load-
carrying capacity of min. 0,1 Watt.
If you want to trigger switching operations automatically, e.g.:
 reed contacts 1 x closing contact (e.g. item-no. 84-53110) and / or
 Hall-sensors (e.g. item-no. 84-53210) and
 permanent magnets (e.g. neodymium magnets Ø 3mm, thickness =
2mm, item-no. 84-53990);
 for the connection via the SUSI connector plug of the deocder: a
SUSI socket with wires (e.g. item no. 70-01111).
If you want to use the output for the servo:
 one servo,
 a voltage supply for the servo (e.g. servo PCB item-no. 70-05900).
Page 7