User manual

English Locomotive decoders of the series 30 plus
Setting the driving of the motor (continuation)
Name of CVs /
registers
No. Input value
(Default)
Remarks and Tips
Alternative
velocity
characteristic
(only with
mode 28
speed levels)
68
.
.
95
0 ... 255 = velocity table for the
alternative velocity
characteristic. Any motor
voltage can be assigned to all of
the 28 speed levels.
0 = voltage of "0"
255 = maximum voltage
Setting the load control
Name of CVs /
registers
No. Input value
(Default)
Remarks and Tips
Parameter of
load control KP
50 0 ... 255 (16) = Proportional component of
the load control.
The parameter KP defines the basic speed.
A too small value à locomotive too slow.
A too high value à heavy shuttering of the locomotive.
Parameter of
load control KI
51 0 ... 255 (14) = Integral component of the
load control.
The parameter KI provides the fine tuning of the load control.
The value has to be adjusted in very small steps.
A too high value à heavy shuttering of the locomotive.
Parameter of
load control KD
52 0 ... 255 (8) = Differential component of the
load control.
The parameter KD retards the transforming of the load control.
A too small value à shaking of the locomotive.
A too high value à rocking of the locomotive.
Motor
adaptation 1
165 0 ... 20 (4) = Factor multiplying the value of
the load control
Motor-
adaptation 2
166 0 ... 20 (1) = Number of averagings of the
measured values of the load
control
Page 64