User manual

English Locomotive decoders of the series 30 plus
Basic settings (continuation)
Name of CVs /
registers
No. Input value
(Default)
Remarks and Tips
Switching off
at overload
(not valid for
LD-G-31 plus and
LD-G-34 plus)
48 --- (45) Determines, at which current
the overload protection
responds. The higher the input
value, the higher is the current
responding at overload
protection.
45 = 1 500 mA
The value of 45 should be
altered as an exception only!
Setting the driving of the motor
Name of CVs /
registers
No. Input value
(Default)
Remarks and Tips
Starting
voltage
(Starting
velocity)
2 0 … 255
(6)
= The voltage to be output to
the motor at speed level 1.
0 = 0 Volt
255 = max. voltage
Acceleration
rate
3 0 … 255
(10)
= Length of the delay before
the switching to the next
higher / lower speed level when
the locomotive is accelerating /
braking.The delay is calculated
as follows:
(value of CV#3) x 0,9 sec. /
number of speed levels
Braking rate 4 0 … 255
(5)
Maximum
voltage
(maximum
velocity)
5 0 … 255
(255)
= The voltage to be output to
the motor at the highest speed
level.
2 = 0,8 % of the max. voltage
255 = maximum voltage
Page 62