Instructions

tams elektronik
LD-G-32.2 and LD-W-32.2 English
Checking the package contents
Please make sure that your package contains:
 one or five locomotive decoders, depending on the version with or
without soldered connecting wires resp. with or without interface
connector;
 a CD (containing the manual and further information).
N.B. For technical reasons it is possible that the PCB is not completely
inserted. This is not a fault.
Available versions
Connecting wires /
Interface
LD-G-32.2 LD-W-32.2
without wires + +
with wires + +
according to NEM 650 8- pole (NEM 652) –
according to NEM 658 – –
according to NEM 660 – –
Required materials
For mounting and connecting decoders without interface you need:
 an electronic soldering iron (max. 30 Watt) or a regulated soldering
iron with a fine tip and a soldering iron stand,
 a tip-cleaning sponge,
 a heat-resistant mat,
 a small side cutter, a wire stripper and a pair of tweezers,
 electronic tin solder (0.5 mm diameter).
Page 5