Instructions

tams elektronik
English LD-G-32.2 and LD-W-32.2
Problems with switching of the functions
 An accessory / a light does not react to switching commands.
Possible cause: The accessory is defective or incorrectly connected.
 Check the accessory / the connections.
Possible cause: The output is defective (e.g. due to overload or short
circuit).  Send in the decoder for check / repair (with costs).
 The lighting goes on and off when the speed levels are turned up or
the lighting cannot be switched on or off.
Possible cause: The speed mode of the decoder and the digital control
unit do not correspond. Example: The central is set to the mode 28
speed levels, but the decoder to the mode 14 speed levels.  Change
the speed mode at the central and / or at the decoder.
Hotline: If problems with your decoder occur, our hotline is pleased to
help you (mail address on the last page).
Repairs: You can send in a defective decoder for repair (address on
the last page). In case of guarantee the repair is free of charge for you.
With damages not covered by guarantee, the maximum fee for the
repair is 50 % of the sales price according to our valid price list. We
reserve the right to reject the repairing of a decoder when the repair is
impossible for technical or economic reasons.
Please do not send in decoders for repair charged to us. In case of
warranty we will reimburse the forwarding expenses up to the flat rate
we charge according to our valid price list for the delivery of the
product. With repairs not covered by guarantee you have to bear the
expenses for sending back and forth.
Page 42