Instructions

tams elektronik
!
LD-G-32.2 and LD-W-32.2 English
9. Check list for troubleshooting
 Parts are getting very hot and/or start to smoke.
Disconnect the system from the mains immediately!
Possible cause: one or more connections are soldered incorrectly.
à Check the connections.
Possible cause: Short circuit between the decoder or accessories
connected to the retrun conductor for all functions and metal parts
of the locomotive or the rails. à Check the connections. A short
circuit can result in irreparable damage.
Problems with the driving characteristics
 After programming the decoder the locomotive does not run or runs
badly.
Possible cause: The set values for the CV are inconsistent.
à Perform a decoder reset and program the decoder anew.
 In digital mode the locomotive suddenly runs very fast.
Possible cause: Interfering signals from the layout have switched the
decoder to analogue mode. à As the origin of the interfering signals´
often cannot be found, it is advisable to switch off the automatic
recognition of the analogue mode during digital operation.
 The CV values cannot be read out by RailCom.
Possible cause: RailCom is switched off. à Alter the value of CV 29
(add "8" to the input value).
Problems in analogue mode
 The locomotive does not run in analogue mode, the decoder does
not work.
Possible cause: The analogue mode is switched off.  Alter the
value for CV 29.
Page 41