Instructions

tams elektronik
LD-G-32.2 and LD-W-32.2 English
Optimising the CV-settings
Above all, the driving characteristics can be influenced by setting the CV
2 (starting voltage) and CV 5 (maximum voltage) and for the decoders
for d.c.motors (LD-G-32.2), in addition, by setting the CV 124
(optimizing the load control) and the CV 50 to 52 (parameters of the
load control).
Make the setting for the load controlled decoder LD-G-32.2 in the
following order, as far as required:
1. CV 124
2. CV 50 to 52
3. CV 2 and CV 5
To adjust the parameters for the load control (CV 50 to 52) the
following procedure is recommended:
If the locomotive is shuttering: à Increase the value for CV 52 (KD) in
5-steps. If this does not lead to an improvement of the driving
characteristics, set the value of CV 52 back to factory setting (default
value). Then decrease the value for CV 50 (KP) in 5-steps and for CV 51
(KI) in 2-steps.
If the locomotive does not have enough power and e.g. gets very slow
on the way uphill: à Increase the value for CV 51 (KI) in 2-steps, until
the locomotive starts to shutter. Then increase the value for CV 52 (KD)
in 5-steps. If this does not lead to an improvement or the locomotive
starts to shutter immediately after increasing CV 51, set the values for
CV 51 and CV 52 back to factory setting (default value) and increase
the value for CV 50 (KP) in 5-steps.
If the locomotive is rocking: à Decrease the value for CV 52 in 5-
steps.
Page 37