Instructions

tams elektronik
English LD-G-32.2 and LD-W-32.2
Programming with the CV-Navi
Instead of programming the configuration variables or registers of the
decoder using the digital central unit, you can use the free software CV-
Navi. You will find the free download under:
www.tams-online.de
A central unit RedBox or Master Control is required for using the software.
8. Configuration variables and registers
The following lists shows all configuration variables (for the DCC
format) and registers (for the Motorola format), that can be set for the
locomotive decoders.
In the lists you will find in the column "CV-no." the numbers of the
configuration variables for programming in DCC format and in the
column "Rg.-no." the numbers of the registers for programming in
Motorola format. The defaults are those values set in the state of
delivery and after a reset.
Please note: With variables destined to set several parameters, the
input value has to be calculated by adding the numerical values
assigned to the desired parameters.
Page 30