Manual

tams elektronik
Power-Splitter tams elektronik
4.2. CV settings
You can adjust the Power-Splitter to individual requirements via main track programming
(POM). With central units that do not support this type of programming, the factory (default)
settings cannot be changed.
Switching to programming mode
To initiate programming of the Power-Splitter, enter the value "62" for CV 7 of any DCC
vehicle decoder address. Proceed as described in the instructions for your central unit. This
entry has no effect on a decoder with the address in question, as no entry is possible for CV 7
of vehicle decoders (= version).
After you have started the programming mode (entered the value "62" for CV 7), the LEDs
flash. You can now change the settings of the Power-Splitter by selecting CV 7 again and
entering a value from the following table for it.
If no value is entered for CV 7 within 30 seconds after starting the programming mode, the
programming of the Power-Splitter is automatically aborted. After a value has been entered,
the programming mode is automatically terminated. If you want to change further values, you
must restart the programming mode by entering the value "62" for CV 7.
14 | Settings / configuration