Manual

tams elektronik
!
tams elektronik Power-Splitter
4. Settings / configuration
4.1. Jumpers
By plugging jumpers onto the jumper field (2x4-pin pin connectors), you make the following
settings:
 Current per booster section: 2 or 3 A
 Number of active booster sections: 2 or 3
Pins Setting Jumper not plugged
in (pins open)
Jumper plugged in
1 Max. current booster section 1 2 amps 3 amps
2 Max. current booster section 2 2 amps 3 amps
3 Max. current booster section 3 2 amps 3 amps
4 Number of active booster sections 3 2 (strings 1 and 2)
Note:
The sum of the current in all booster sections must not exceed the maximum output current
of the booster. Otherwise, the overcurrent shutdown of the booster reacts and switches off
all booster sections, even if the maximum current set for the booster sections has not been
exceeded. In this case, all booster sections are always switched off, regardless of the short
circuit behaviour set for the Power-Splitter.
Front side Power-Splitter
Version "Ready device"
Settings / configuration | 13