Manual
Table Of Contents
- 1. Getting started
- 2. Your B-6
- 3. Conception of the digital layout
- 4. Connections
- 5. Settings / Configuration
- 6. Operation
- 7. Update
- 8. Checklist for troubleshooting and error correction
- 9. Technical data
- 10. Warranty, EU conformity & WEEE
tams elektronik
Booster B-6 tams elektronik
Display Colour
of the RGB LEDs
Meaning
ot.
orange-red flickering:
"Overtemperature" / overheating
Immediately disconnect the booster from the
power supply. Eliminate the cause of the
overheating (obstruction of air exchange, very
high ambient temperature or direct sunlight).
As soon as the booster has cooled down, you
can put it back into operation.
--
blue flashing: BiDiB-Identify
The B-6 reports to the PC control software via
BiDiB (BiDiB-Identify).
To stop sending the signal, press the button
again until the RGB LEDs light up green or red
again.
rE
violet rising and falling: Reset
After the reset, the B-6 automatically switches
back to standard operation.
| || |
alternating with
– –
Update
The B-6 automatically switches back to
standard operation after the update.
Adjusting the Brightness of the RGB LEDs
You can adjust the brightness of the RGB LEDs:
→ section 5.2 "Main track programming", input values for CV 7: 90 ... 98 (90 = minimum
brightness | 98 = maximum brightness)
32 | Operation