User manual

tams elektronik
English Booster B-4
Display
In the version art.-no. 40-19417 the booster B-4 has a two-digit 7-
segment display. During operation it shows the present current [A]. After
a short circuit the remining seconds till the re-switching on are displayed.
In addition, the display shows the following operating status:
Display Meaning
− −
− −
The booster has been switched off by a points
switching command.
− −
− −
The watchdog has been released and the booster
has been switched off in consequence.
This version also enables you to read out and display the current
booster´s settings.
In order to read out the settings, input the value "62" for CV#7 for any
DCC locomotive address. Proceed as described in the manual of your
control unit. After having chosen CV#7 again and set a value from the
following list for this value, the current setting is shown.
Value for CV#7 Currently set value
91 Autostarting time after 5 short circuits
92 Limiting value for short circuit warning [A]
93 Watchdog:"ON" = active, "OF" = inactive
94 Switching off command: "ON" = active, "OF" =
inactive
95 Software release
96 Autostarting time after a short circuit [sec.]
97 Railcom. "ON" = active, "OF" = inactive
98 Track voltage [V]
99 Max. track current (interrupting current) [A]
Page 24