Instructions
Table Of Contents
- 1. Getting started
- 2. Commissioning
- 3. Your mc²
- 4. Connections
- 5. Configuring the system (Submenu "System")
- 6. Operation with the mc²
- 7. Updates
- 8. Checklist for troubleshooting
- 8.1. Heat generation
- 8.2. Automatic safety shutdown
- 8.3. Problems with the power supply
- 8.4. Problems with external input devices
- 8.5. Problems when programming and controlling vehicles
- 8.6. Problems when switching points and other accessories
- 8.7. Problems with s88 modules
- 8.8. Problems with the software update
- 8.9. Technical hotline
- 8.10. Repairs
- 9. Technical data
- 10. Warranty, EC Conformity & WEEE
tams elektronik
6.3.3. DriveControl.vi
Select up to four vehicle decoders that you want to control. To do this, enter the addresses
directly in the input fields or click the arrow keys to increase or decrease the set address by
1 each.
You can change the speed level for the selected vehicle decoders using the sliders, change the
direction of travel and switch the F0 function on and off.
You can go from DriveControl.vi directly back to HandControl.vi.
6.12 | Operation with the mc²
Speed
controller
Change to
HandControl.vi
Full screen mode on/off
Direction change-
over switch
Function
key F0
Decoder
adresses