Instructions

tams elektronik
!
4.2.2. Devices for the LocoNet
Info
The LNet connector allows the connection of digital devices whose data transmission is done
via the LocoNet developed by Digitrax.
Connection: RJ12
For the connection of
 FRED hand controller from Uhlenbrock
 DAISY 2 hand controller from Uhlenbrock
 SmartControl light from Piko
 LocoNet booster
 LocoNet accessory decoder
 LocoNet feedback
Note: The control of boosters and accessory decoders for
LocoNet as well as the forwarding of feedback signals from
LocoNet are not yet supported. (Status: 04/2021).
Possible applications of the LocoNet input devices
You can use the input devices that you integrate into the digital control system via the
LocoNet interface
 to control vehicle decoders for Motorola, DCC and mfx (the latter in m3 format) or
 to switch accessory decoders for Motorola and DCC
However, it is not possible to program decoders or configure the digital system using LocoNet
input devices.
Power supply of the devices at the LocoNet interface
LocoNet handheld control devices are usually powered via the bus line. Other LocoNet digital
devices such as command stations, boosters or accessory decoders have their own power
supplies.
Notice:
The total current of all external digital devices that are connected to the various interfaces of
the mc² and do not have their own power supply must not exceed 1.2 A. Otherwise, the
mc² automatically switches off the power supply for the external devices.
4.4 | Connections