Instructions

tams elektronik
RedBox English
Configuration variables for the DCC format (exert)
CV# CV name Value
(Default value)
Explanations
1 Primary address 0 ... 127
(3)
The primary address contains a value between 1 and
127. Is the CV#1 equal to 0, the decoder switches to
analog mode.
2 Vstart 0 ... 255
(-)
Defines the current powering the engine at minimum
speed.
3 Acceleration rate 0 ... 255
(-)
Defines the duration of the pause while switching up
to the next higher speed level.
4 Deceleration rate 0 ... 255
(-)
Defines the duration of the pause while switching
down to the next lower speed level.
5 Vhigh 0 ... 255
(0)
Defines the current powering the engine at maximum
speed.
6 Vmid 1 ... 255
(1)
Defines the current powering the engine at moderate
speed.
7 Manufacturer
version No.
1 ... 255 This is the version number of the decoder’s internal
software.
8 Manufacturer ID e.g. 62 In this case: Tams Elektronik GmbH
9 Total PWM period 0 ... 255
(0)
The current powering the electric motors is facilitated
by switching on / off the power. The interval
between those power peeks is called PMW period. By
altering the PMW period, the individual running
characteristics of an electric motor are changed.
17 +
18
Extended address 1 ... 10239
(-)
Defines the address between 1 and 10239, if the
decoder is set to extended addresses.
19 Consist address 0 ... 127
(-)
Defines the alternate (second) address of the
decoder.
29 Configuration data
#1
0 ... 255
(-)
Defines main properties of the decoder: Driving
direction, amount of speed steps, switching to analog
operation, additional feedback while in programming
mode, choice of the speed table, primary addresses
or extended addresses.
33 –
46
Output Loc. FL(f),
FL(r), F1-F12
0 ... 255
(-)
Contains a matrix indication of which function inputs
control which Digital Decoder outputs.
Seite 48