User manual

PZS-3 English
Page 49
Programming step 2: Setting the phases´length
By adjusting the trimmer you set the length of the phases accelerating,
halt and braking for the 5 stops. In state of delivery the phases are set
to the shortest possible length. Test the module with these settings
first. Choose the stop you want to program (see programming step 1)
and prolong the phases by turning the adjusting screw to the right.
N.B: The settings only take effect if you save them (see programming
step 3).
Trimmer Phase Min. length (approx.)
Trimmer A R30 Accelerating 1 sec.
Trimmer A R1 Braking 1 sec.
Trimmer A R29 Halt 4-5 sec.
Programming step 3: Saving the settings
After having set the phases´length for a stop at the trimmer, connect
the programming input „save“ (16) to earth (short pulse) (4).
N.B: Before closing the earth contact make sure the LED on the module
flashes. If it does not the module is not in the programming mode and
you cannot save any settings. The number of the light pulses between
the pauses indicates for which stop the settings at the trimmer are
saved.
As long as the connection to earth is held the LED lights and indicates
that the settings are saved.
Tip
Especially if you use all possible connections of the module we advise
you to mount push-button switches (not included in the package) into
the connections between the programming inputs and the earth
connection.