User manual

English PZS-3
Page 48
Extra halts
By connecting the switching input „extra halts“ to earth an extra halt is
released immediately and independent of the place where the train
momentarily is. In order to close the earth contact you can use
switches or external circuits (e.g. signal control circuits).
N.B: The length of the phases accelerating, halt and braking is set
jointly for all extra halts.
Programming the shuttle-train control
Programming the length of the phases is done the same way for the five
different stops (two terminus stations, two stops, all extra halts). Carry out
the programming steps 1 to 3 for all stops you want to program.
Programming step 1: Choosing a stop
Intermittently earth the programming input „select“ (17) to point (4).
The LED on the module flashes and thus indicates the 1
st
stop is ready
to be programmed. By connecting the programming input once again to
earth you switch to the programming of the next stop. The number of
flashlights between the pauses indicates the one of the five stops
ready to be programmed.
If you do not want to program a stop you can skip this halt by
connecting the programming input once again to earth.
If you connect the programming input once again to earth after having
reached the programming of the 5
th
stop the module automatically
returns to standard operation.
Stop Number of flashlights Stop ready to be programmed
1 1 Terminus station 1
2 2 Stop 1
3 3 Terminus station 2 (both rails)
4 4 Stop 2
5 5 Extra halt(s)