User manual

PZS-3 English
Page 45
Connecting the shuttle-train section
Section connection
point
cutting
point
Outer conductor / all sections 13
Terminus station 1 18 A
Terminus station 2 8 D
Free section
If required it is possible to install "free sections" between the
terminus stations and the stops.
5 B
Stop 1 (way there) and Stop 2 (way back)
It is possible to divide the section C into two parts and if
neccessary to seperate them by a "free section", in case the
two stops for the two directions are not situated at the same
place.
9 and 6 C (1, 2)
Stop 1 only (without stop 2) 9 C (1)
Stop 2 only (without stop 1) 6 C (2)
Additional connections
Points at terminus station 2
In case you do not use stop-points you should connect an
extra bistabile relais according to fig. 3 to the points (not
included in the package).
return line: 1
switching contacts:
14, 15
Switching input „prolonging the halting time“
(at a stop) or "emergency stop" (while
motion)
7, earth: 4
Switching input „extra halts“ 12, earth: 4
Programming input „save“ 16, earth: 4
Programming input „select“ 17, earth: 4