User manual

tams elektronik
!
!
FCS modules English
stored software. They light as soon as the module is connected to the
power supply.
Connect the anodes (+) of the LEDs to the soldering point X2 and the
cathodes (-) to the soldering point X3.
Caution: The LEDs for the front lighting must be operated via
series resistors (recommended value: 100 ). Otherwise the
connected LEDs are damaged and the circuit may not work as
intended.
7.4. Mounting the FCS-4
Preparation
Open the housing of the vehicle. Locate the position for the module.
Disconnect all connections from the accumulator batteries, the motor
and the mounted reed contact except for the wire to the charging
contact.
Follow the connection diagram in the centre of this handbook and the
explanations to the special features of the additional components
(section 6).
In many vehicles the resistor R7 shown in the connection diagram is
mounted into the lead-in wire to the motor. The resistor has to be
connected to the plus pole of the accumulator batteries if not yet
mounted that way. If there is no resistor, R7 is not applicable.
Connection to the supply voltage
Connect the connecting point X2 to the plus pole of the accumulator
batteries and the minus pole of the accumulator batteries to the
existing switch S of the vehicle. Connect the second pole of the switch
to the connecting point X1.
Caution: The module should not be connected the wrong way
round. Otherwise it will be damaged when put into operation!
Page 53