User manual

tams elektronik
English FCS modules
Connection of the LEDs for the front and back lights
The two LEDs for the front lights have to be connected in parallel, i.e.
the anodes (+) of the LEDs both have to be connected to X4. Connect
the two cathodes (-) to the resistors R8 and R9 (10 ). Connect the
disconnected ends of the resistors to the connecting point X3.
The two LEDs for the stop and back lights have to be connected in
series, i.e. the anode (+) of the one LED has to be connected to the
cathode (-) of the other LED. Connect the disconnected anode (+) to
connecting point X6 and the disconnected cathode (-) to connecting
point X3. Additional series resistors are not necessary for the operation
of the LEDs for the stop and back lights.
Setting the sensitivity of the light
Before closing the housing of the vehicle, you should set the sensitivity
of the dim switch to the desired lighting conditions. First set the trim
pot to mid-position and change the sensitivity as far as necessary. The
circuit requires 3 or 4 seconds to react.
7.3. Mounting the FCS-3
Preparation
Open the housing of the vehicle. Locate the position for the module.
Disconnect all connections from the accumulator batteries, the motor
and the mounted reed contact except for the wire to the charging
contact.
Follow the connection diagram in the centre of this handbook and the
explanations to the special features of the additional components
(section 6).
In many vehicles the resistor R7 shown in the connection diagram is
mounted into the lead-in wire to the motor. The resistor has to be
connected to the plus pole of the accumulator batteries if not yet
mounted that way. If there is no resistor, R7 is not applicable.
Page 50