User manual

tams elektronik
!
!
FCS modules English
7. Mounting
7.1. Mounting the FCS-1
Preparation
Open the housing of the vehicle. Locate the position for the module.
Follow the connection diagram in the centre of this handbook.
Connection to the supply voltage
Connect the soldering point X1 to the negative pole and the soldering
point X2 to the positive pole of the accumulator batteries.
Caution: The module should not be connected the wrong way
round. Otherwise it will be damaged when put into operation!
Connection of the LEDs for the flashlights
Connect the anodes (+) of the LEDs to the soldering points X4 to X8
and the cathodes (-) to the soldering point X3. Note the different
functions of the outputs. Additional series resistors are not necessary
for the operation of the LEDs for the flashlights.
When you want to run program 2 ("Alternating flashlight") you have to
make a connection between the soldering points X9 and X3. Otherwise
the program 1 ("Double flashlight") is performed.
Connection of the LEDs for the front light
You may connect up to two white LEDs for the front lighting to the
module. Connect the anodes (+) of the LEDs to the soldering point X2
and the cathodes (-) to the soldering point X3.
Caution: The LEDs for the front lighting must be operated via
series resistors (recommended value: 100 ). Otherwise the
connected LEDs are damaged and the circuit may not work as
intended.
Page 47