User manual

tams elektronik
FCS modules English
Connection of the LEDs for the flashlights
Connect the anodes (+) of the LEDs to the soldering points X4 to X8
and the cathodes (-) to the soldering point X3. Note the different
functions of the outputs. Additional series resistors are not necessary
for the operation of the LEDs for the flashlights.
When you want to run program 2 ("Alternating flashlight") you have to
make a connection between the soldering points X9 and X3. Otherwise
the program 1 ("Double flashlight") is performed.
Programm 1
"Double flashlight"
Programm 2
"Alternating flashlight"
X3
Voltage output (-)
of the circuit
Voltage output (-)
of the circuit
X4 LED1 Double flashlight
Alternating
double flashlight
X5 LED2 Double flashlight
X6 LED3
Alternating
double flashlight
Alternating
flashlight
X7 LED4
X8 LED5 Double flashlight Flashlight
X9
Input of the circuit
à open
Input of the circuit
à connected to X3
Page 21