Instructions

tams elektronik
!
English MT-1 | MT-2 | MT-3
11. Check list for troubleshooting
 Parts are getting too hot and/or start to smoke.
Disconnect the system from the mains immediately!
Possible cause: one or more components are soldered incorrectly.
à In case you have mounted the module from a kit, perform a
visual check (à section 6.) and if necessary, remedy the faults.
Otherwise send in the module for repair.
 The lamp connected for the functional test of the module does not
light.
Possible cause: one or more components are soldered incorrectly.
(MT-1: e.g. D2, MT-2: e.g. D1). à Alter the mounting direction.
Possible cause: The lamp is defective. à Check the lamp by
connecting it directly to the voltage supply.
 MT-2 only: The module does not switch.
Possible cause: The length of time the input is connected to ground
is shorter than the selected time delay. à Reduce the time delay or
lengthen the time the input is connected to ground.
Seite 32