Specification Sheet

5554
PAGE MODEL FOCAL LENGTHmm ANGLE OF VIEW (diagonal) ( ) = values for cameras with APS-C sensor LARGEST APERTUREf SMALLEST APERTUREf APERTURE BLADES LENS CONSTRUCTION Elements/groups MINIMUM OBJECT DISTANCEcm MAX. IMAGE RATIO FILTER SIZE Ømm WEIGHT
5
g
DIAMETER × LENGTH
6
mm
CANON DSLR NIKON DSLR SONY DSLR PENTAX DSLR MFT (Micro Four Thirds)
FOR MIRRORLESS SYSTEM CAMERAS (DSLM) LENS HOODS (included) NOTES

Di II
For digital SLR cameras with APS-C sensor
SP AF 60mm F/2 Di II LD [IF] MACRO 1:1
48 G005 60
26°11’
2 22
7
14-10 23 1 : 1 55 350 73.0 × 80.0 HG005
10-24mm F/3.5-4.5 Di II VC HLD
2
42 B023 10-24
108°44’–60°20’
3.5-4.5 22-29 7
2
rounded blades
16-11 24
3
1 : 5.3 77 440 83.6 × 82.1 HB023
Optionally available: TAP-in Console
16-300mm F/3.5-6.3 Di II VC PZD MACRO
1
36 B016 16-300
82°12’–5°20’
3.5-6.3 22-40 7
2
rounded blades
16-12 39
3
1 : 2.9 67 540 75.0 × 99.5 HB016
SP AF 17–50mm F/2.8 XR Di II VC LD Aspherical [IF] 47 B005 17-50
78°45’–31°11’
2.8 32
7
19-14 29
3
1 : 4.8 72 570 79.6 × 94.5 AB003
SP AF 17–50mm F/2.8 XR Di II LD Aspherical [IF] 47 A16 17-50
78°45’–31°11’
2.8 32
7
16-13 27
3
1 : 4.5 67 440 73.8 × 83.2 DA09
18-200mm F/3.5-6.3 Di II VC
1
39 B018 18-200
75°33’–7°59’
3.5-6.3 22-40 7
2
rounded blades
16-14 49-77 1 : 4 62 400 75.0 × 94.1 HB018
18-270mm F/3.5-6.3 Di II VC PZD
1
39 B008TS 18-270
75°33’–5°55’
3.5-6.3 22-40
7
16-13 49
3
1 : 3.8 62 450 74.4 × 88.0 DA018
18-400mm F/3.5-6.3 Di II VC HLD
2
34 B028 18-400
75°33’-4°
3.5-6.3 22-40 7
2
rounded blades
16-11 45
3
1 : 2.9 72
710 (Canon) 705
(Nikon)
79 × 123.9 (Canon)
79 × 121.4 (Nikon)
HB028
Optionally available: TAP-in Console

Di III For mirrorless system cameras
14-150mm F/3.5-5.8 Di III
40 C001 14-150 75°22’–8°15’
*
3.5-5.8 22 7
2
rounded blades
17-13 50
3
1 : 3.8 52 285 63.5 × 80.4 HC001
Available in two colour versions: Black and Silver; * angle of view for aspect ratio 4 : 3
18–200mm F/3.5–6.3 Di III VC
40 B011 18-200 75°33’–7°59’ 3.5-6.3 22-40 7 17-13 50
3
1 : 3.7 62 460
**
68.0 × 96.7
**
Canon:
Sony:
HB011
For mirrorless APS-C system cameras from Canon and Sony; available in two colour variants: Black
and Silver; ** weight and diameter × length (total length) values apply to the corresponding model
with Sony mount.
28-75mm F/2.8 Di III RXD
10 A036 28-75
75°23'-32°11'
(52°58'-21°05')
2.8 2.8-22
9
2
rounded blades
15-12 19-39 1 : 2.9 67 550 73.0 × 117.8 Sony: HA036 for SONY E-mount with full-format sensors
Notes on model B011
When using the AF-C mode (Continuous AF) with 18-200mm Di III VC, please note:
• When using the scene program “Sports Mode”, during continuous focusing,
“pumping” of the image may occur on the LCD monitor display. If this
occurs, it will not affect the quality of the image that is produced.
• The same effect may be observed in any of the Shoot Modes
(P, A, S, M) when Continuous AF (AF-C) is used. The effect will
not affect the photos taken in this situation either.
* As an alternative to the situation described above, the focus mode can
be set to Single Shot AF (AF-S) or Direct Manual Focus (DMF).
Be careful if the camera shows an error message or if the LCD monitor goes
blank (for Canon lenses). In very rare cases, malfunctions can occur if signal
transmission between the camera and the lens does not work correctly.
If this occurs, please do one of the following to solve the problem:
• Switch the camera off.
• Ensure there is no dirt or oil on the signal contacts in the lens and/or the camera.
• If the problem continues, please switch the camera off and remove the
battery. Re-insert the battery and switch the camera back on.
Notes
The use of Di and Di II lenses with mirrorless compact camera
systems is not recommended. The use of a conversion adapter
(mount adapter, converter etc.) should also be avoided.
1
SONY DSLR
The Sony mounts (A005, A007, A009, A010, A011, A012, B008, B016, B018,
F012, F013, F016, F017, A022) are supplied without VC image stabilisers, as Sony’s
digital single lens reex cameras are already tted with an internal image stabiliser.
As a consequence, the abbreviation “VC” is missing in these lens designations.
2 The blades form an almost circular shape when the aperture is open. This shape
is maintained almost fully even when stopping down by up to two stops.
3 Minimum object distance over the entire range of focal lengths.
4 Weight including the removable tripod mount ring. Unless otherwise speci-
ed, the information refers to the model with the Nikon mount.
5 The length is dened from the contact face on the camera housing to
the tip of the lens. The weight and diameter x length values, excluding
C001, B011 and A036, apply to the model with the Nikon mount.
LENS OVERVIEW
NEW
Lens hoods
All Tamron lenses are supplied with a lens
hood as standard that is made specially for the
specic lens. This lens attachment prevents
lateral light rays entering the lens and thereby
minimises the risk of dispersion and
ghost
images on the inside of the lens harming the
quality of the image.
On lenses with internal
focusing (IF), the lens hood is somewhat
longer and is tulip-shaped, preventing
shadowing in the corners of the picture.