Operation Manual

GB-5
Removing the unit
1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's
negative (-) terminal.
2. Press the button to remove the front panel.
3. Remove the surround by gently pulling it up to detach it.
4. Insert both of the supplied release keys so that they release the left and right sides of the
bracket and then pull the unit out of the dashboard.
USING THE DETACHABLE FRONT PANEL
REMOVING THE DETACHABLE FRONT PANEL
The front panel of the unit may be removed as a theft deterrent. After removing the front panel, use the case provided to prevent it
from getting damaged.
1. Press the button to release the front panel.
2. Gently slide the front panel to the left to remove it from the unit.
3. Store the front panel in the protective case.
ATTACHING THE FRONT PANEL
Hold the right side of the front panel with the controls facing towards you.
First attach the right side of the front panel to the unit by inserting it into the right-hand notch.
Then push the left side of the front panel in so that it is completely attached to the unit.
WIRING DIAGRAM
Many vehicles are fitted with ISO connectors behind the dashboard, which makes it easier to connect your car radio. These connections can be
found in the dashboard where the car radio will be fitted. Use these cables to connect the car radio. Should your car not be fitted with these ISO
connectors, we strongly advise you to consult your car dealer or a specialist to obtain the right adaptor. Once you have these cables, you will
need to connect your loudspeakers and the power supply to the ISO connector, following the connection instructions below.