Operation Manual

GB-4
- Install the unit where it will not get in the driver's way and cannot injure the passenger if there is a sudden or emergency stop.
- Do not install the unit where it would be subject to high temperatures, direct sunlight or near a heat source. Also avoid contact with
dust, dirt and excessive vibrations.
Installation Opening
This unit can be installed in any dashboard that has an opening with the following dimensions (DIN
standard):
Installing the unit
1. Make sure the ignition is turned off, and then disconnect the vehicle’s battery.
2. Remove the surround by carefully pulling it up to detach it.
3. Use the two release keys supplied to remove the unit from the mounting bracket. Insert the left and right release keys so that they
release the left and right sides of the bracket.
Then take the unit out of the bracket.
4. Mount the bracket by inserting it into the dashboard opening and bend out the tabs
located around the sleeve with a screwdriver. Not all tabs will be able to make contact, so
choose the ones that best match the size of the opening. To secure the bracket, bend out
the appropriate tabs so that they hold it in place in the dashboard.
5. Connect the wire harness and the antenna (see “Wiring diagram” in next section),
being careful not to pinch any wires or cables.
6. Use the equipment supplied (Hex Nut (M5mm) and Spring Washer fixed on the back of
the unit) to attach to a solid metal part of the vehicle beneath the dashboard.
7. Fit the detachable front panel to the car radio in order to check the connections. Briefly
connect the battery to do this. Once you have checked the connections, slide the unit into
its bracket until you hear a click. Next fit the surround.
8. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the
surround and install the unit's front panel (see the section 'ATTACHING THE FRONT
PANEL').