Instructions / Assembly

Page 4

Connect to fan to power using factory-

installed power cord (10 ft).

Suspend fan from rafters using hanging strap.

Secure hanging strap to rafters using wood screws

(1½" minimum length, NOT provided) through the

pilot holes on strap; washers recommended between

screw heads and straps. USE BOTH SIDES OF

STRAP AND KEEP FAN AS LEVEL AS POSSIBLE.

FAN INSTALLATION

All wiring connections to and from fan are

made at fan-mounted electrical box.

Face of fan must remain unobstructed; 24-

INCH MINIMUM CLEARANCE REQUIRED.

Route all wiring away from face of fan to

prevent entanglement.

Install AirDoor within the framing around the rough opening.

From below, secure the AirDoor to the framing using wood

screws through the pilot holes in its sides. Mounting anges

can be attached to the AirDoor to assist.

Use a high-quality latex caulk to seal all wood-to-wood and

wood-to-metal seams within the rough opening.

Use bolts to fasten fan cone to fan and latches to fasten

ductwork to fan cone.

Once the fan, fan cone, ductwork, and AirDoor have been

successfully connected, seal these seams with the provided

aluminum tape.

Seal the AirDoor’s outside seams with the provided aluminum

tape at: 1) each corner; 2) where the transition meets the

sides; and, 3) over all unused pilot holes.

Tamarack HV5500G Whole House Fan Installation Manual, P/N HV5500G.1