Spec Sheet

6. How do I perform a “Factory Reset”?

a) Factory Reset allows you to return the Hub to the original factory settings. All

information added to the Hub will be forgotten after the reset is performed.

b) There are two methods of performing a factory reset to the Hub.

 1

Method: From the Tamarack app, within the Diagnostics menu.

Select the Hub from the Device Management screen to be reset.

Select the Gear Icon, located at the upper-right of the screen.

Select Diagnostics.

Press Factory Reset.

Press Reset.

 2

Method: With access to the installed Ghost Hub location.

Access the two buttons marked as Join and Fan on the face of the Hub.

Press and hold the two buttons until two LED’s start to blink.

Release the buttons, the Factory Reset is complete.

 After a factory reset has been performed repeat the “Out of box” instructions

to begin the setup process from the beginning. Listed on page 2, Step 1.

Optional: Wiring manual switches to bypass the wireless Hub to control the fan.

There are wires located in the junction box hard mounted to the Wi-Fi Hub to allow for the use of two SP/ST (single pole /

single throw) wall switches to bypass the Wi-Fi Hub method of control. When the manual switches are in use the fan

cannot be turned off using the app or changed to low speed if the speed switch is set to high speed. See wiring instructions

portion of the installation manual for details.