Series Installation Guide
Table Of Contents
- Introduction
- Customer Support
- Tools Required
- Components List
- Pre Assembly for Models STP-LCR/82HW STP-LCR/124HW
- Step 1: Connecting Panel Support Channels (STP-LCR/124HW only)
- Step 2 Connecting inner\outer brace channels
- Step 3: Connecting Panels to Panel Supports
- Final Assembly
- Step 4: Attach Pole Clamp Assembly to Pole
- Step 5: Attach Tilt Plate Mounting Channel
- Step 6: Attach Tilt plates
- Step 7: Attach Cross Rails to Tilt Plates.
- Step 8: Attach Panel Support Sub Assembly to Cross Rails
- Step 9: Install Knee Brace Cross rail STP-LCR/82HW STP-LCR/124HW
- Step 10: Adjust Tilt Angle
- Step 11: Install Lower Vee Brace STP-LCR/82HW STP-LCR/124HW
- Detailed Diagrams for Assembly
- Foundation Hole Guidelines (see charts pages 14, 15)
- Footing Chart 2 panel STP-LCR/82HW
- Footing Chart 3 panel STP-LCR/124HW
- Installer Responsibility
- Warranty Information
