Series Installation Guide
Table Of Contents
- Introduction
- Customer Support
- Tools Required
- Components List
- Pre Assembly for Models STP-LCR/82HW STP-LCR/124HW
- Step 1: Connecting Panel Support Channels (STP-LCR/124HW only)
- Step 2 Connecting inner\outer brace channels
- Step 3: Connecting Panels to Panel Supports
- Final Assembly
- Step 4: Attach Pole Clamp Assembly to Pole
- Step 5: Attach Tilt Plate Mounting Channel
- Step 6: Attach Tilt plates
- Step 7: Attach Cross Rails to Tilt Plates.
- Step 8: Attach Panel Support Sub Assembly to Cross Rails
- Step 9: Install Knee Brace Cross rail STP-LCR/82HW STP-LCR/124HW
- Step 10: Adjust Tilt Angle
- Step 11: Install Lower Vee Brace STP-LCR/82HW STP-LCR/124HW
- Detailed Diagrams for Assembly
- Foundation Hole Guidelines (see charts pages 14, 15)
- Footing Chart 2 panel STP-LCR/82HW
- Footing Chart 3 panel STP-LCR/124HW
- Installer Responsibility
- Warranty Information
STP HW Mount
Series
10
ANGLE
A
B
C
0° 27.06 6.50 36.56
10° 27.06 8.50 41.27
20° 25.06 8.50 48.76
30° 25.06 16.50 46.14
40° 15.06 18.50 51.19
50° 15.06 26.50 49.74
60° 5.06 30.50 56.80
ANGLE A B C
0° 19.17 6.50 40.97
10° 19.17 8.50 44.45
20° 15.17 8.50 50.00
30° 15.17 18.50 43.60
40° 15.17 26.50 38.79
50° 1.17 26.50 48.51
60° 1.17 32.50 49.21
Location Chart STP-LCR/124HW
Location Chart STP-LCR/82HW
DETAIL M
(STP-LCR/124HW shown)
DETAIL N DETAIL O