Tamarack Flush Mount Rail System Data Sheet
Two Rail Sizes in Mill Finish
2.3-inch rall for heavy loads
and longer spans and 1.6-inch
rail for low-prole mounting
and areas with low snow load.
Patent-Pending 50-50 Bonding Clamp
One clamp can be used as a mid-clamp or an end-clamp
on modules with 30 mm to 40 mm frame height.
Push-In Bonding Rail Splice
Quickly splice and bond rail
sections with no tools or fas-
teners. Top Clamps and Rail
Mounts can be co-located with
splice.
Channel End Clamp
Simple device to allow modules to be
mounted ush to the end of the rail.
Push-On End Cap
Can be used with
50/50 Clamp or
Channel End-Clamp.
Rail Mount and L-Foot
Quickly and securely mount
the rail from either side, to
any L-Foot, Tile Hook or spe-
cialty ashing with a hole or
slot for 5/16-inch bolt.
Wire Management Clip
Push into top of rail to
keep cables in place.
Tamarack Flush Mount makes it easy to stock
parts and quickly install a PV system
Ground lug
Use one per module
row to ground rail with
bare 6 to 10 AWG cop-
per wire.
MLPE Adapter
Use for mounting
microinverters and
optimizers on the
rails under the solar
modules.