Tamarack instruction manual
2019 TAMARACK SOLAR - REVISION G FLUSH MOUNT MANUAL
6
Attach Rail Mounts
Each Rail-Mount consists of two parts, a 5/16 inch bolt and a clamp
extrusion. The rail adapters have been designed to interface with o-
the-shelf mounting products that have vertical leveling slots. Our Rail
Mounts work with most products that have 5/16 inch or 3/8 inch bolt
slots. We also oer our own L foot for mounting to products that have
a at mounting surface, such as seam clamps, exposed beams or Quick
Mount Q Blocks.
Install Rails
Rails are sold in convenient 126 inch lenths. This length
is enough for three 60 cell or 72 cell modules with a width
of up to 40.5 inches. Use a Tamarack bonding splice to
connect each section of rail in a row.
If a cut section of rail is required for the installation, it
must not be installed at the end of a row. Each section of
rail at the end of a row must be supported by two mounts
before being spliced. If a rail section has a splice and 3 roof mounts, the splice should be lo-
cated within 1/3 rail span of the middle mount.
Rail mounting is simple and easy.
The Rail Adapter clamps to the
two feet on the bottom of the rail.
There is never any drilling, and
parts can be brought on the roof
fully assembled and ready to be
installed. Rail Adapters may be
installed anywhere on the rails,
including at splices and they will
not interfere with module mounting clamps.
Simply position the adapter into the two feet on the bottom of the rail, and tighten the bolt
slightly. Leave the bolt slightly lose to allow leveling of the rails in the next step.