Installation Manual

4
info@ | tamaracksolar.com | [phone]
2016 v1.01
Step 3. Attaching Panel/Arm Assembly to Bracket
Place the panel/arm assembly on the bracket as shown.A.
Installation Manual Single Arm
Insert 5/16-18 x 3/4” bolt and at washer from the inside
out. Place a at washer, lock washer, and hex nut
on the outside. This orientation allows you to tighten the
bolt with just one wrench.
Adjust the tilt of the panel as desired, and tighten the bolts
to 144 in-lbs (dry).
B.
C.
15°
15°
75°
15° alignment holes for
flat surface mounting
for pole mounting
15° alignment holes
75°
15°