Manual

６-２-３ POS

Setup the protocol and baud rate of the POS device.

６-２-４ Event Source

Select {Menu}  {Setup}  {Camera}  {Event Source}.

(1) Motion Area

The user can setup the motion detection area. Area setup related to motion can be decided.

[Figure 6-45. Motion Area Setup]

① Select Motion Area of each channel.

② It becomes the 1 channel division mode and rectangular boxes appear where motions occur. Drag

the yellow pixel cursor by using the mouse or the front button/remote controller and select pixels w

here motion detection doesn’t applied. The selected area turns brown.

③ Select Exit to finish.

(2)Motion Sensitivity : Lowest/Low/Middle/High/Highest.

(3)Sound Sensitivity : Lowest/Low/Middle/High/Highest

(4)Sensor Type : Select the sensor type.

(5)EOL : EOL Function Select (On / Off).

６-２-５ Relay

Select the relay type.

６-３ Recording

The Main setup is to configure the environment of record and system and major functions.

In the real-time monitoring, move to {Menu}  {Setup}  {Recording}