Manual

② Read the information and select {Yes} to start the upgrade gradually. Select {No} to return to the

{System} mode.

③ After the upgrade is completed, the system reboots.

④ Move to {Menu} {Miscellaneous} {DVR Information}  {3. Software Version} to check the

version.

(3) Setup Upgrade

① Select {Setup} and the upgrade file list stored in the selected device and simple version info of

the selected file are then displayed.

② Select a file and then the upgrade starts immediately.

Select a file and then the upgrade starts immediately. All setting values of the

current menu will be changed to the upgrade setting values.

６-７-７ Factory Default

① Move to {Menu}  {Setup}  {System}  {7. Factory Setup}.

② Select {Yes} when Initialization (Yes/No) Window appears.

Note that all setting data will be initialized.

※ All values go back to Factory Default Value.

６-７-８Console / POS Port

① Move to {Menu}  {Setup}  {System}  {8 Console / POS Port}.

② On the selection window, select the device by using the arrow keys and the Select button.

６-７-９ Alarm

Alarm is to notify system incidents [Video Signal loss/ HDD full/ FAN fail/ HDD fail/ HDD warning] through

[Buzzer/ E-mail/ Relay01/ System check].

Select each [Off/Buzzer/E-mail/Relay01/Popup Window] by ticking.

※ Popup Window

Setup at {Menu}  {Setup}  {System}  {9. Alarm}.

Popup Window is to pop up the system check window in the

monitoring screen as shown. it indicates [Video Signal loss/ HDD

full/ HDD Not Detect / FAN fail/ Storage Fail/ Storage Warning /

Sensor Connection Tamper].

６-７-１０ Alarm Duration

① It sets the duration of the alarm triggered by the recording and system event.

② Move to {Menu}  {Setup}  {System}  {10. Alarm Duration}.

③ In the selection window, set Alarm Duration by using the arrow keys and the Select button.

６-７-１１ Menu Time Out

If no input is made in the System Setup menu from the front buttons, remote controller and mouse, the system

automatically shifts to the real-time monitoring mode.

① Move to {Menu}  {Setup}  {System}  {11. Menu time Out}.

② In the selection window, select the time zone you want to set by using the arrow keys and the

select button.